Insert 1911 mag netica DAA

Efficient and fast system to transform the IPSC holster from one pistol model to another by changing the insert block assembly. Just press a button and you won't lose any of your holster settings or configuration.

Valid for DAA Alpha-X or Race Master holster

In used is necessary to make some slight adjustments in the insert block so that the trigger guard is perfectly anchored.

The insert set includes:

• trigger guard housing block (weapon specific)
• Paddle nca of lock (weapon specific)
• Sliding lock (already mounted and weapon specific)
• Activation system mag internal netic, assembled.
• Logo mag netic to cover a lateral hole in holster s still have.

To disassemble your insert follow these steps:

1. Remove the insert from the holster removing the M4 screws from the back of the holster .
2. Using a Teflon boots and hammer push the two steel bolts from the front to the rear of the block. Push from the side where the insert gun model is engraved. These pins may be tight.
3. Once both bolts are out, the wedge holding the second magnet will pop out.
4. To remove the slide lock, unscrew the M3 screw visible from the back of the block - and then slide the slide lock.